Water Jet Prep | OBDF 221A | Feb 5.W2026

-

Material: 22 gauge copper wire (perhaps)

Thickness: 0.644 mm

Project: Phone stand 


3D Render:





The Unfolded Geometry:



The Final 2D Cutting Layout:




评论

发表评论

此博客中的热门博文

🧊Refreshing Relief🧊: The Comfort of Cold Lemonade in Summer (OBDF110_F2024)

-
图片
Summer brings to mind the refreshing taste of lemonade, that a glass of iced lemonade and the light fragrance of lemon relieve the heat and irritability. Below is a glass of lemonade with half a lemon and a straw that I made for the first time by using the rhino.  The addition of straws and lemons makes the whole look less monotonous, and the choice of glass keeps the whole piece from being top-heavy. □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □   □  □   □   □   □  ╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌╌ Below are three views of this work. □   □   □   □   □   □  ...
阅读全文

Castle_OBDF210B_F2025

-
图片
 Hello :) For this "castle," I decided to go with a slightly "easier" approach, almost no circles or curves. Honestly, I really think building with circles and curves is way harder than just sticking to cubes and rectangular prisms. Curves will give you more creative freedom, but anyway, putting together a castle with clean, straight rectangular prisms feels sooo satisfying, that every piece is neatly controlled. I mainly used " Box ," " BooleanDifference ," " Polyline ," " Mirror ," and " Rotate " for this castle, but honestly, I just clicked on their icons from the left toolbar since I didn't remember all the names, oops.  Note to self: if you're decorating all four sides of a building, don't forget to use "Rotate." I totally skipped it once, and then couldn't figure out why some sides of my columns ended up looking bare... mystery solved! The biggest challenge with this castle was that I ...
阅读全文

3D Printed 'Attachment': Object Selection & IDEATION | Oct 2025

-
图片
  Choose 1 Object: laptop stylus, and laptop Reason:  My laptop doesn't have a dedicated slot for a stylus, and I easily lose it. Theerefore, I think this project is a good opportunity for me to solve this problem. 'Attachment' (connector): Locate- I plan to place the 'attachment' on the left side of the laptop keyboard. I don't use the left side laptop ports often, and the 'attachment' can be easily removed, so I think this is a suitable installation location. Notice- 1. Cannot affect the laptop's shutdown                 2. The connector near the screen (top) can be made on four sides (it has been confirmed that there is always a small gap between the screen and the keyboard regardless of screen rotation), while the other side can only be made on three sides, (no the keyboard surface).                3. The "height" of connector should not be too long Sketch- (Left: perspective from left to righ...
阅读全文